pvsblur — Average the amp/freq time functions of each analysis channel for a specified time.


Average the amp/freq time functions of each analysis channel for a specified time (truncated to number of frames). As a side-effect the input pvoc stream will be delayed by that amount.


fsig pvsblur fsigin, kblurtime, imaxdel


fsig -- output pv stream

fsigin -- input pv stream.

kblurtime -- time in secs during which windows will be averaged .

imaxdel -- maximum delay time, used for allocating memory used in the averaging operation.

This opcode will blur a pvstream by smoothing the amplitude and frequency time functions (a type of low-pass filtering); the amount of blur will depend on the length of the averaging period, larger blurtimes will result in a more pronounced effect.

[Warning] Warning

It is unsafe to use the same f-variable for both input and output of pvs opcodes. Using the same one might lead to undefined behavior on some opcodes. Use a different one on the left and right sides of the opcode.


Here is an example of the use of the pvsblur opcode. It uses the file pvsblur.csd.

Example 656. Example of the pvsblur opcode.

See the sections Real-time Audio and Command Line Flags for more information on using command line flags.


sr = 44100
ksmps = 16
nchnls = 1
0dbfs = 1

;; example written by joachim heintz 2009

instr 1
ifftsize	=		1024
ioverlap	=		ifftsize / 4
iwinsize	=		ifftsize
iwinshape	=		1; von-Hann window
Sfile		=		"fox.wav"
ain		soundin	Sfile
fftin		pvsanal	ain, ifftsize, ioverlap, iwinsize, iwinshape; fft-analysis of the audio-signal
fftblur	pvsblur	fftin, p4, 1; blur
aout		pvsynth	fftblur; resynthesis
		out		aout

i 1 0 3 0
i 1 3 3 .1
i 1 6 3 .5

See Also

pvsanal, pvsynth, pvsadsyn


Author: Victor Lazzarini
November 2004

New plugin in version 5

November 2004.