Description

midinoteonkey is designed to simplify writing instruments that can be used interchangeably for either score or MIDI input, and to make it easier to adapt instruments originally written for score input to work with MIDI input.

In general, it should be possible to write instrument definitions that work identically with both scores and MIDI, including both MIDI files and real-time MIDI input, without using any conditional statements, and that take full advantage of MIDI voice messages.

Note that correlating Csound instruments with MIDI channel numbers is done using the massign opcode for real-time performance,. For file-driven performance, instrument numbers default to MIDI channel number + 1, but the defaults are overridden by any MIDI program change messages in the file.

Syntax

midinoteonkey xkey, xvelocity

Performance

xkey -- returns MIDI key during MIDI activation, remains unchanged otherwise.

xvelocity -- returns MIDI velocity during MIDI activation, remains unchanged otherwise.

If the instrument was activated by MIDI input, the opcode overwrites the values of xkey and xvelocity with the corresponding values from MIDI input. If the instrument was NOT activated by MIDI input, the values of xkey and xvelocity remain unchanged.

This enables score p-fields to receive MIDI input data during MIDI activation, and score values otherwise.

	Adapting a score-activated Csound instrument.
	See the MIDI interop opcodes section for details on adapting score driven instruments for MIDI or vice-versa.

Examples

Here is an example of the midinoteonkey opcode. It uses the file midinoteonkey.csd.

<CsoundSynthesizer>
<CsOptions>
; Select audio/midi flags here according to platform
-odac    -M1 -Q1  ;;;realtime audio out and midi in and midi out
;-iadc    ;;;uncomment -iadc if realtime audio input is needed too
; For Non-realtime ouput leave only the line below:
; -o midinoteonkey.wav -W ;;; for file output any platform
</CsOptions>
<CsInstruments>

sr = 44100
ksmps = 32
nchnls = 2
0dbfs  = 1

instr 1	;uses external midi device

kkey init 0						;initialize key number
kvel init 0						;initialize velocity
midinoteonkey kkey, kvel				;MIDI note number value 
printk2	kkey						;display the key value when it changes and when key is pressed 
midion 1, kkey, kvel					;sent note to external device

endin
</CsInstruments>
<CsScore>
f 0 30	;runs for 30 seconds	

i 1 0 2 62	; play these notes from score as well
i 1 + 2 65
e
</CsScore>
</CsoundSynthesizer>

Its output should include lines like:

 i1    60.00000
 i1    69.00000
      

See Also

midichannelaftertouch, midicontrolchange, mididefault, midinoteoff, midinoteoncps, midinoteonoct, midinoteonpch, midipitchbend, midipolyaftertouch, midiprogramchange

Credits

Author: Michael Gogins

New in version 4.20